by e2tech » Wed Apr 23, 2014 2:37 pm
I just downloaded the ViewmatePro trial software. Been a long time user of Deluxe and when I saw you now have centroid data generation figured I would give it a try. So I followed the procedure laid out as far as creating the new footprint and then generating centroid data from this new file. The issue is when I generate the centroid file it is creating far more data than what is there. There are roughly 90 footprints in the new footprint file, but it's exporting well over 1000 different part numbers and locations. When I view the new centroid gerber file generated it shows the correct outlines for the approximate 90 components, but the "id" number is overwritten several times on almost all of the components but a couple. Any ideas on what I did incorrectly? Thanks!