Sentinel Protection Installer Fails

Sentinel Protection Installer Fails

Postby marius » Mon Jun 18, 2012 9:12 pm

If one gets the following error when trying to install the Sentinel Protection Installer:

Snap1.png


the error can be caused by a conflict on port 6001.

Sentinel System Driver utilizes port 6001, we have seen reports where other application like National Instrument Software’s “Lab View” product uses the same port 6001 and such port conflict would cause Sentinel Protection Installer’s installation to fail.

Check whether port 6001 is being used by another application (you can use the DOS command of: netstat –a ). If yes, stop that application and the Sentinel Protection Installer installation should complete successfully.
You do not have the required permissions to view the files attached to this post.
marius
 
Posts: 179
Joined: Tue Dec 01, 2009 10:25 am

Return to Installing CamMaster Software

Who is online

Users browsing this forum: No registered users and 1 guest

cron